Home >> Blogs >> BMC Product Post-treatment And Crate Mould Cleaning

this user is offline now  xiuumin
Send message



July 2020
June 2020
May 2020
April 2020
March 2020
February 2020
January 2020
December 2019
November 2019
October 2019
September 2019
August 2019
July 2019
June 2019
May 2019
April 2019
March 2019

Who Gives Kudos:



BMC Product Post-treatment And Crate Mould Cleaning

(1) Post-treatment of products

The moulding shrinkage of the prefabricated integral moulding compound is very small, and the shrinkage and warpage of the product are not serious. For some products, if the above phenomenon occurs, it can be put into an oven for slow cooling to eliminate it.

(2) Product finishing

Because prefabricated integrally moulded products often have some burrs attached to them, they need to be removed. The maximum thickness of burrs shall be limited to 0.1 mm. If the thickness of burrs is too large, it will not only be difficult to remove, but also the material waste will be too large and the cost will be greatly increased. If time permits, the operator can clean burrs and holes on the product using tools such as cutting blades, embossing belts and press-in rods during the time interval between the closing and curing of the Crate Mould(FURNITUREMOULD). Smaller products usually use roller edges to remove burrs.

(3) Cleaning the crate mould

After taking out the product, carefully clean the crate mould. First of all, the residual prefabricated integral moulding plastic chips, flash and other chips in the crate mold should be completely removed, especially the materials that have penetrated into the gap of the joint surface of the cavity should be completely removed, otherwise, not only the surface quality of the product will be affected, but also the opening and closing and exhaust of the crate mould may be affected.

Compressed air, brushes and copper non-ferrous metal tools are usually used to clean the crate mould to prevent damage to the cavity surface during cleaning. After cleaning the crate mould, apply a certain amount of release agent to the area where adhesion may occur, and then carefully check whether there are other foreign matters in the cavity. After completing the above work, you can proceed to the next process.

Click Dustbin Mould to learn about more information.

Mood: Crate Mould
- 0 Comments - 0 Kudos - Add comment 

Copyright © 2009 - 2012 True2ourselves. All rights reserved.
Reproduction in whole or in part in any form or medium without express written permission is prohibited.