Home >> Blogs >> Changing The Size of The Cavity Through The Mould of The Household Product Mould

this user is offline now  xiuumin
Send message



August 2020
July 2020
June 2020
May 2020
April 2020
March 2020
February 2020
January 2020
December 2019
November 2019
October 2019
September 2019
August 2019
July 2019
June 2019
May 2019
April 2019
March 2019

Who Gives Kudos:



Changing The Size of The Cavity Through The Mould of The Household Product Mould

The degree of shrinkage is also known as "shrinkage factor", and if these shapes shrinkage factor accurately known both scientific and from experience, by preparing the Household Product Mould(FURNITUREMOULD) so that the dimensions of the cavity slightly larger the amount of shrinkage is possible to form the moulded.

Also, in the long term will still shrinkage place, although to a lesser extent. Crystalline polymers shrink much more than amorphous polymers, some polymers have shrink 10%.

The value of the shrinkage is normally displayed as a percentage (%). Normally, the shrinkage is between 0.2 to 2%.Thus ABS has low shrinkage 0.5% and PP a higher contraction around 1.5%.

Further, the shrinkage factor is influenced by the following factors.

1. Type of press material

The range of the base shrinkage factor is determined is used by the type of plastic material. However, there will be fine vary, depending on the material of the manufacturer and the quality of the material.

2. Cavity surface

The moulding shrinkage factor depending on the cavity surface temperature of household product mould. In general, the shrinkage factor tends to be large when the temperature is high.

3. Maintain pressure × pressure maintenance time

The moulding shrinkage factor depending on the magnitude of the pressure is maintained after plastic injection, and maintain the point of time that pressure. In general, there is the trend in shrinkage factor smaller and smaller when the high pressure is maintained and the pressure maintenance is long.

4. Thickness of the household product mould

The shrinkage factor also depends on the wall thickness of the household product mould. There is a trend in the shrinkage are greater as the wall thickness increases.

5. nose injection-moulding mould

The shrinkage factor is dependent on the shape and the size of the spuitgietneuas. In general, there is a trend that the shrinkage is becoming increasingly smaller as the cross section of the gate is increased.

6. Presence or absence of additives to the moulding material

It is very common that there is a big difference in shrinkage factor between natural materials and materials with glass fibers. It is generally streams that the shrinkage factor is smaller for materials with glass fibers.

Click Daily Necessities Mould to learn about more information.

Mood: Household Product Mould
- 0 Comments - 0 Kudos - Add comment 

Copyright © 2009 - 2012 True2ourselves. All rights reserved.
Reproduction in whole or in part in any form or medium without express written permission is prohibited.