Home >> Blogs >> The Nozzle Extends to The Bottom of The Air Cooler Mould

this user is offline now  xiuumin
Send message



September 2020
August 2020
July 2020
June 2020
May 2020
April 2020
March 2020
February 2020
January 2020
December 2019
November 2019
October 2019
September 2019
August 2019
July 2019
June 2019
May 2019
April 2019
March 2019

Who Gives Kudos:



The Nozzle Extends to The Bottom of The Air Cooler Mould

The melt typically flows from the nozzle into the nozzle, but for an Air Cooler Mould(FURNITUREMOULD), the nozzle is part of the air cooler mould because it extends to the bottom of the air cooler mould. There are two main types of nozzles: open nozzles and closed nozzles. In injection moulding, open nozzles should be used more because they are cheaper and less likely to stay. If the injection moulding machine is equipped with a pressure reducing device, the nozzle can be used even if the viscosity is low.

It is sometimes necessary to use a closed nozzle that acts as a shut-off valve and blocks the shadow of the plastic in the spray cylinder. Make sure the nozzle is properly inserted into the nozzle sleeve. The top hole is slightly smaller than the nozzle sleeve, which makes the nozzle easier to remove from the air cooler mould. The hole of the interface sleeve is 1 mm larger than the nozzle opening, ie the radius of the nozzle is 0.5 mm thinner than the radius of the nozzle sleeve.

The impurities of the plastic can be removed by the filter of the extensible nozzle, i.e. the melt and the plastic flow through the passage which is divided into narrow spaces by the insert. These narrow and gaps remove impurities and improve the mixing of the plastic.

Therefore, to extend it, you can use a fixed mixer to achieve better mixing. These devices can be mounted between the firing slot and the nozzle to separate and remix the melt, primarily to allow the melt to flow through the stainless steel tank.

Click Furniture Mould to learn about more information.

Mood: Air Cooler Mould
- 0 Comments - 0 Kudos - Add comment 

Copyright © 2009 - 2012 True2ourselves. All rights reserved.
Reproduction in whole or in part in any form or medium without express written permission is prohibited.