Home >> Blogs >> Pressure Control During Crate Mould Cycle

this user is offline now  xiuumin
Send message



October 2020
September 2020
August 2020
July 2020
June 2020
May 2020
April 2020
March 2020
February 2020
January 2020
December 2019
November 2019
October 2019
September 2019
August 2019
July 2019
June 2019
May 2019
April 2019
March 2019

Who Gives Kudos:



Pressure Control During Crate Mould Cycle

The actual pressure applied should be higher than the full chamber pressure. During the injection process, the Crate Mould(FURNITUREMOULD) pressure rises sharply and eventually peaks. This peak is the so-called injection pressure. The injection pressure is significantly higher than the full chamber pressure.

The effect of pressure on the pressure: after the cavity is filled with plastic until the gate is completely cooled and closed for a period of time, the plastic in the cavity still needs relatively high-pressure support, ie maintaining pressure, the specific role is:

The amount of material near the gate is replenished and the uncured plastic in the mold cavity is controlled to flow back to the gate material source under residual pressure before the gate condensation is closed.

Prevent parts from shrinking and reduce vacuum bubbles.

Reduce the adhesion or bending deformation caused by excessive injection pressure of parts. Therefore, the holding pressure is usually 50% to 60% of the injection pressure. If the holding pressure or time is too long, the gate may be too large. The cold material on the flow violently hits the part, adding bright spots near the gate and extending the loop without any benefit.

Click Dustbin Mould to learn about more information.

Mood: Crate Mould
- 0 Comments - 0 Kudos - Add comment 

Copyright © 2009 - 2012 True2ourselves. All rights reserved.
Reproduction in whole or in part in any form or medium without express written permission is prohibited.